STEP 1.REMOVE THE COMPLETE TAIL SECTION OF THE 600RR-1000RR LIKE SHOWN IN THE PICTURE.

STEP 2.REMOVE THE PLASTIC FACTORY FENDER REMOVING THE 4 8MM OR 10MM BOLTS THAT HOLD IT ON.

STEP 3.AFTER REMOVING THE 8MM OR 10MM BOLTS THAT HOLD ON THE FACTOR FENDER THEN CUT THE WIRING AS LONG AS YOU CAN THIS WILL ASSIST YOU IN MAKING CONNECTIONS LATER.          

STEP 4.ASSEMBLE THE FENDER ELIMINATOR LIKE SHOWN IN THE PICTURE.

STEP 5.ATTACH THE LEDS TO THE PLATE USING THE HARDWARE PROVIDED.

STEP 6.BOLT THE NEW FENDER ELIMINATOR BACK ON THE BIKE USING THE FACTORY HARDWARE.

THE SOLID ORANGE AND BLUE WIRES ARE POSITIVE LEAD WIRES.

THE SOLID GREEN WIRES ARE NEGATIVE LEAD WIRES.

ON THE TAG LIGHT WIRES THE BROWN WIRE IS POSITIVE AND THE GREEN IS NEGATIVE.

STEP 7.MAKE THE CORRECT CONNECTIONS TO THE LEDS USING THE WIRE COLORS ABOVE.

STEP 8.REATTACH THE TAIL SECTION ON THE BIKE.

THIS IS WHAT YOUR KIT SHOULD LOOK LIKE !!!
 

WE HAVE CUSTOM INTEGRATED TAIL LIGHT FOR THE HONDA CBR 600-1000RR SPORTBIKES.

LED UNDERLIGHTING KITS

STARTING AT